1. Connect the NVR to the power supply and then connect it to a monitor via an HDMI or VGA cable. The camera is directly connected to the NVR's PoE network port with a network cable.
   

    

   
   

2. 
   

      If your camera needs to be connected to a switch, please follow this diagram for installation and click          this link to configure the camera.

temple link

       If there is no normal image displayed on the display screen, please click the link below to check or                 contact our official line or email.

1. Enter the page of language selection , select the corresponding language, and then go to the page where you enter the initial password for the NVR. Enter the default password 12345 for the NVR，and enter the page for setting passwords. The password newly set must contain letters, numbers, and a special symbol.

1. After setting the new password, the NVR will pop up this prompt. Please click cancel and do not enable this function.

1. If you clicked confirm, please click this link to resolve the issue.

   Temporary link

   Then enter the startup wizard

   Select the corresponding time zone

1. Click Enable DHCP option

1. 
   

   Return to the menu.