1. Download the IPC manager software on the computer. 

Download link: https://drive.google.com/drive/folders/1tBqoe2dHP-zsZfpLY1Yj74b_0W7H8-4E

2. Connect your computer to the same network as the camera. Then check your computer network information like below. 

Note: You can go to the Control panel of your computer first, then click 'Check network status and assignments' under 'Network and Internet' setup, then click the network that you are connected to and click 'detailed information'. 

3. Follow the steps below to change the camera`s IP address.

• Input the user name and password. The default user name is admin, and default password is 12345. 

• Tick the camera.

• IP From: The first three numbers of IP address should be same as your computer`s IPv4 address (Router IP address). You only need to change the last number.

For example, if the computer`s IP address is 192.168.1.9, you can change the camera`s IP address to 192.168.1.99. The last part number should be between 2-254. It is not recommended to use numbers that are too early, because this may cause IP conflicts. The later the number, the lower the probability of IP conflicts.

• Subnet Mask: Keep it same as your computer.

• Gateway: Keep it the same as your computer.

4. Click ‘Modification ’ to save settings. 

5. Click Refresh to see the camera`s new IP address.